Dentemp^® Pro-Comfort

Instructions:

1. Heat water, 2-3 inches deep, until it reaches a rolling boil.

2. Remove boiling water from heating source and let stand for 10 seconds.

3. Carefully submerge the Pro-Comfort in the hot water for 30 seconds.

4. Using the slotted spoon or fork, carefully remove the Pro-Comfort from the hot water.
CAUTION: Before placing the Pro-Comfort in your mouth, test its temperature with the tip of your finger. The Pro-Comfort should be at a warm and comfortable temperature.

5. Using a mirror, center the dental guard on your upper front teeth and the sides below your molars.

6. Gently bite down on the Pro-Comfort, and form the material to your teeth and gums by sliding and pressing your fingertips inside your mouth or against your cheeks. NOTE: Do not clench down excessively.

7. Press your tongue firmly against the roof of your mouth, and with a light sucking action, create a vacuum chamber effect by drawing out all the air and water.

8. Continue forming the Pro-Comfort with your fingertips.

9. After a total of at least 2 minutes in your mouth, place the Pro-Comfort in a bowl of cold water for 5 minutes.

10. You should now have a snug, custom-fit Pro-Comfort. If necessary, you may repeat the fitting process 1 more time to improve your fit.

After each use, inspect your Pro-Comfort for excess wear. If grind-through is detected, it is time to replace your dental guard before the next use. Otherwise, brush your dental guard with toothpaste and rinse with cool water. Avoid using hot water. Dry thoroughly and use the provided case to store your Pro-Comfort when not in use.

Warnings:

Do not use: Any dental product without first consulting with a dentist; As an athletic guard; If you are under 18 years of age; If you have TMJ pain or clicking of the jaw; If you have teeth or jaw pain; If you have loose teeth; If you have dental implants, braces, dentures, or other dental appliances; For more than 3 months without consulting with a dentist. Ask a dentist before use if you have: Serious health problems such as respiratory issues; Mouth sores, bleeding gums, or gum disease; Cavities without fillings, loose fillings or tooth caps; Difficulty chewing, jaw or teeth pain; Two or more missing teeth. Stop use and ask a dentist if: You develop loose teeth or a change in your bite; Experience pain, bleeding gums or other irregularities; The product falls out of your mouth easily or causes you to gag; The product disrupts breathing. See a dentist every 6 months.

Frequently Asked Questions:

Q: Can it be refitted?
A: Yes, It can be fitted up to 2 times.

Q: Does it go on the upper or lower teeth?
A: It is designed for the upper teeth.

Q: Does it contain latex?
A: No

Q: Can a child wear it?
A: No. All dental guards for bruxism (teeth grinding) are intended for use for ages 18 and up. Children under the age of 18 are still in development so dental guards for bruxism are not recommended.

Q: Does it adhere to dental work like caps?
A: Please consult with your dentist before using a dental guard with any dental appliances. Any dental work could prohibit from getting a proper fit.

Q: Can I wear it during the day?
A: It is designed to be worn at night while sleeping.

Q: I have TMJ, can I use this product?
A: Please consult with your dentist. It is not advised to use if you have TMJ.

Q: What if I don't get a good fitting and it falls off?
A: Sometimes it doesn't seem the material softens enough to mold to the bottom teeth. Try to refit the guard and leave it in the hot water for 45 seconds vs the 30 seconds on the directions. Also, be careful not to bite down too hard.

Q: My teeth hurt after fitting, what should I do?
A: It may take up to a week to get used to a new device in the mouth, but do not continue prolonged use if the pain is still there after a week.

Q: Should I use Dentemp if I have throbbing pain or swelling in the affected area?
A: No. You should consult your dentist immediately. This may be an indication of infection.

Q: When replacing a cap or crown, should I put the cement directly into the center of the cap or crown?
A: No. Place a small amount of the cement on the upper inside wall of the cap or crown. Place the cap or crown on the tooth and press firmly for several minutes.

Q: When replacing a lost filling, how do I get the ball of cement to stay in the hole?
A: Place the ball on the tip of your finger and put the ball into the hole of your tooth. Then disengage the cement from your finger by scraping your finger along the side of your tooth.

Q: Should Dentemp be used on a post or implant?
A: It differs from case to case. Before using on a post or implant, seek your dentist’s advice.

Q: Can Dentemp be used to repair a broken tooth?
A: No. You should consult your dentist.

Q: Can Dentemp be used to repair a denture?
A: No. You should use Repair-it or consult your dentist.

Q: Will I get sick if I accidentally swallow Dentemp?
A: No.

Q: Is there any type of crown on which Dentemp should not be used?
A: No. Dentemp can be used on any type of crown.

Q: What is Eugenol?
A: Eugenol is the active ingredient in clove oil. Eugenol helps to alleviate pain.

Q: Can I use Dentemp if I am nursing? If I have a latex allergy? If I have high blood pressure?
A: Yes. Yes. Yes.

Q: Can I use Dentemp while pregnant?
A: Consult your obstetrician.

Q: Is Dentemp gluten free?
A: Yes.

Q: Can Dentemp be used on children?
A: Consult your dentist or pediatrician.

Q: My pet got a hold of the product and swallowed it, is it toxic?
A: Product is nontoxic.

Q: Can product be used on gold crowns?
A: It depends on how the crown is made. It may work.

Q: Can product be easily removed by dentist?
A: Yes.

Q: Can product be used to attach fangs for Halloween?
A: No. Product is not intended for this use.